ShareGoo Adjustable Aluminum Pull Rod Steering Servo Link Linkages Arm Tie Rod Ends Compatible with WLtoys 144001 1/14 RC Car Buggy

These feature M3 turnbuckle-style studs which means one end has normal right-hand threads and the other end has reverse (left hand) threads. For some reason the product details of this and similar products does not mention that important fact. I recently purchased an alternative to this and discovered that, unfortunately, both ends were right hand threaded. I'm happy to say this one meets my expectations.Overall, I feel the materials and construction are high quality. Very happy with my purchase.

Herd to put in but looks good

Might not work for your application.The pull rods can easily bend. Even with minor bump.They are easy to adjust but extremely difficult to make the adjustments permanent. They loosen up after the first or second ride.Original plastic parts might be a better option.

This product seems cheaply made. I installed the front pieces " steering linkage and upper arm linkage". Just a few minutes into the first run after their installation, the silver spacer piece where you mount them just fell out. This caused excessive play in the linkages and the drive shaft fell out.

Nice metal

I only tried to install the tie rods for steering but the screws and nuts stick out to far and hit other parts.

These are ok the WL buggy itself is a bit of a pain to work on tho .

These were ok except that the hole for the bolts is too small for the one that threads into the shock mount. It comes with smaller bolts and nuts, but the holes should fit the proper size ones that are used on the car.

Avec un peu d ajustement et en coupant une partie du système de roulement ca fonctionne sur le deerc 9200. Piece px9200-17

The links use a thinner screw than OEM. This requires a nut to fasten to the 144001, since it won't thread on directly. The bolts obstruct handling of the 144001 and can't be used.Others have made the same comment. Wish I had read the comments before buying.