System Three T-88 Epoxy Adhesive, 1 Quart Kit

I used this to glue a handle onto a beer stein I made (it didn’t glue on straight 😢) and also used it for ice cream scoopers and bbq spatulas. It’s solid as a rock once it’s set. I would also grab some wood clamps, this stuff takes about 12-18 hours to dry.I would definitely buy again!

Building a home built microlight glider made of Sitka spruce... and let me say that this stuff is the boss! This epoxy has been used for decades by wooden aircraft builders and has a great reputation ... and now I know why! May take a while to get used to measuring just the right amount for the task, but this stuff is strong and does not shrink. It sands fairly easily. You can glue just about anything to anything! Stronger than the wood itself... if it’s been well verified and tested for use on wooden aircraft where your life literally depends on it, I’m sure it’ll be fine for your furniture or boat builds also...highly recommend.

I have used this material for a number of years in both the construction and marine trades and am very satisfied with the results, though it sets up in 20-30 minutes it does achieve full hardness after 24 hours, yet once it is cured it is rock solid, there are several cautions, one is surfaces to be mated have to be free of any grease or oils, second does not work well below forty degrees, it takes paint very well especially on boat hulls etc, it will discolor over time to a brownish hue if left raw but strength does not break down in full sunlight.

I glued 3/4 "Coosa Bluewater composite board for my additional helm console project and the epoxy set up after 12hrs having a rock hard bond. What happened after I applied the Gel coat was disappointing because the epoxy seam reacted with the Gel coat which left a tacky surface. At this point I tried brushing some epoxy catalyst from another product hoping it kicks in the cure. If I had no such reaction I would of given it a five star.Update three weeks later. The catalyst I applied from another resin product helped cure the tacky areas which I described above. Also, the MFG rep recommended using System Three SB-112 when applying a Gel coat over the resin. I changed my opinion from 3 to 4 stars and as stated would have given 5 stars if I didn't encounter the reaction which could of been caused by either the Gel coat or T-88. Using T-88 without the Gel coat is a clear 5+. Customer service were very responsive.Update 3 months later changed from 4 star to 5 star! I have now mounted the new hydraulic helm and Morse control after mounting the new console on the aft deck. It has no signs of weakness. Very sturdy. I have also since used the same Gel coat for the wheelhouse deck and the Gel coat exhibited some areas which did not fully kick in were as this only happened previously at the new console epoxied joints. Not sure why so I upgraded to 5 star and would recommend this epoxy to a friend.

I've been using this epoxy for my knife handles that I make for 8 or 9 years and never had a failure! Great epoxy!!

I’ve used T-88 since 1992 on boats and airplanes. Easy to work with and absolutely permanent if you follow instructions. My project was delayed a week because someone chose to ship by USPS. Never had a problem with UPS but PS is a frequent foul up.

Great item well packed smooth transaction

The best epoxy...and the strongest I've ever used...